Cutrine-Plus is a liquid formulation which contains 9.0% active ingredient.

Contains 0.909 pounds of copper per gallon.

Has a specific gravity of 1.21 (10.1 lbs. per gallon).

Controls algae at 0.2 to 0.4 ppm copper and hydrilla at 0.4 to 1.0 ppm copper.

Controls all three forms of algae: planktonic, filamentous and chara

Cutrine-Plus is applied at a rate of 0.6 gallon per acre-foot (43,560 cubic feet) of water to be treated for planktonic and filamentous algae, 1.2 gallons per acre-foot for Chara and Nitella and 1.2 to 3.0 gallons per acre-foot for Hydrilla.

Cutrine-Plus should be diluted with at least 9 parts of water to facilitate even distribution during application. Surface spray is most practical for treatment of planktonic and filamentous algae. Bottom-growing algae should be treated by underwater injection or by application of Cutrine-Plus Granular. Hydrilla can be treated by surface spray or underwater injection.

Cutrine-Plus need sunlight to optimize effectiveness.

Cutrine-Plus is not completely effective against Pithophora and diatoms.

Cutrine-Plus can be toxic to trout, at the recommended application rates, if the water has less than 50 ppm of carbonate hardness (soft water). Do not use in waters containing Koi and hybrid goldfish. Not intended for use in small volume, garden pond systems.

Cutrine-Plus has proven to be the favorite algaecide for fish growers because they can calculate and apply the exact amount of copper they desire. It can reduce or eliminate taste and odor problems caused by geosmin and MIB producing blue-green algae. It can be used to reduce the incidence of secondary bacterial or fungal infections by reducing the phytoplanktonic irritants which can expose the gill surfaces of the fish.

Always read and follow label when using this product.

---

Labeled Application Rates:

• Cutrine-Plus- is applied at a rate of 0.6 gallon per acre-foot (43,560 cubic feet) of water to be treated for planktonic and filamentous algae, 1.2 gallons per acre-foot for Chara and Nitella and 1.2 to 3.0 gallons per acre-foot for Hydrilla.

• Cutrine-Plus should be diluted with at least 9 parts of water to facilitate even distribution during application. Surface spray is most practical for treatment of planktonic and filamentous algae. Bottom-growing algae should be treated by underwater injection or by application of Cutrine-Plus Granular. Hydrilla can be treated by surface spray or underwater injection.
• See label for all usage details and for weeds controlled

   

---

Other Product Suggestions

For burndown of weeds above water use: Glyphomate 41

 We also have Blue Pond dye. Beautify your pond with True Blue!

Read and follow all local, state and federal regulations pertaining to the use and application of this products before ordering.

Due to governmental regulation, we do not ship this product to the following states: CA, NY and OR.

---

Special Licensing or Registration: Most products sold on this site do not require a license for purchasing and using them; however, some states may vary in their requirements. Some products sold on this website may require the special licensing training or registration of the user with that user's state, county, city, province, etc. You are responsible for providing a license, permit, registration, etc., if required by your local or state authorities. Most states or counties in the U.S.A. will provide a license or personal use permit for a nominal fee. It is your responsibility—and not that of KeystonePestSolutions.com or its affiliates - to verify that any products purchased are licensed for distribution and use in your state, county, city or province, etc.

---

Disclaimer: Purchaser is responsible to read the Product Label and Use requirements for this product. KeystonePestSolutions.com assumes no liability for the use or misuse of these products and makes no guarantees other than what the maunfacturer of this product will stand behind.

EPA Reg. # 8959-10